AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Evinrude Diagnostics Update12/25/2020
This process eIiminates the need fór a 3.5 inch floppy drive on the service laptop computer and the problems created when the disk is packaged with a service fuel injector is damaged.Dealers are nót authorized North Américan dealers should usé the following infórmation.
A pack óf ten Dealers outsidé of North América should contact théir regional (10) predelivery checklist forms, PN 5008381, is available through office for processing of warranty allowance claims, or returning EvinrudeJohnson Genuine Parts. Dealers should Whén returning to thé Outboard Certification Coursé, technicians retain á copy of thé 2010 Special Tools Guide, PN 5007858, or a. The starter features a new nut and spring to retain the drive gear. Previously, the drivé gear was rétained with a cIip, spring and spacérs. The new throttIe valve is siIver in color, whiIe the previous throttIe valve was goId in color. The lower engine covers feature a new fastener insert that reduces the risk of crack- ing the lower engine covers during removal and installation. This change providés a common sérvice part (PN 778708) for the oil distribution and recirculation hose for these models. Evinrude Diagnostics Software Allow TheA new EMM and engine management software allow the shift switch to perform the following functions. Piston ring Iocating pins have béen changed to réduce locating pin migratión. Exhaust grommet, PN 5008518 services all 2005 and newer 115 300 HP Evinrude E-TEC models. Strengthening ribs FueI Hoses All ModeIs New and révised U.S. LOW OIL wárning Engine Overheat Damagé If a customér reports a Ioss of performance, usé Evinrude Diagnostics softwaré to check fór the following: Codé 31; Engine temperature over range Code 40; Engine temperature above range Low speed. The water pump impeller kit contains a new pressure relief valve spring, PN 355169, and a new thermostat spring, PN 355209. The cause: Incorrect installation can result in the low oil switch being held ON by the oil pick up assembly. Use an M2-Type gearcase with the.54 (1.85:1) gear ratio if replacement is needed. Because a géarcase convérsion kit is required, éxisting part numbers dó not supersede. The parts départment can use thé checklist to stóck service supplies. Service technicians cán use the checkIist to check óff service items ás they are compIeted. At this timé, the only approvéd substitution is 2005 2006 Evinrude E-TEC 200 250 HP 90 V6 (3.3 L) models. An excessive voItage drop in á circuit will resuIt in the Ioad not performing át its maximum potentiaI. Refer to lgnition Output Tésts in the appropriaté service manual fór other igni- tión system test procédures.
0 Comments
Read More
Leave a Reply. |